Aqua Rite Salt Cell Manual

Reset average salt level the average salt level needs to be reset after initial start up after a board replacement following major pool chemistry adjustments and when a cell is replaced.

Aqua rite salt cell manual.

These levels are low enough that it normally will not be tasted. Check salt when flashing the salt level is low below 2700 ppm and aqua rite is generating at low efficiency. It is important to maintain these levels in order to prevent corrosion or scaling and to ensure maximum enjoyment of the pool. Salt cell was cleaned serviced with no change.

How to reset the average salt level displa. The check salt inspect cell led s will flash when the cell reports the salt level is between 2400 2700ppm. In this condition chlorine is still being produced. The check salt inspect cell led s will be on when the cell reports the salt level is 2300ppm or less.

T 15 is the factory default. In this condition chlorine production is interrupted. Operation the aquarite 900 series is an automatic chlorine generation system for pool or spa sanitation. T 15 is the factory default.

I replaced salt cell and readings went to 3500 but hasn t changed even with significant rain diluting pool. Ifthe incorrect cell is chosen the salt level amperage and voltage will not be correct and the system will turn the chlorinator off. Page 4 before operation the aqua rite must be configured for the chlorinator cell that will be used. Slide the main switch to the auto position.

How to set turbo cell type before operation the aqua rite must be configured for the chlorinator cell that will be used. Page 10 how to. Step 1 step 2 3200 1600 to reset move the switch to off and then back to auto. Page 6 salt level use the chart on page 4 to determine how much salt in pounds or kgs need to be added to reach the recommended levels.

The only special requirements for the aqua rite are the salt level and stabilizer. Before adding large quantities of salt it is advisable to have your salt level professionally checked. My aqua rite was not reading salt level correctly. Page 4 before operation the aqua rite must be co nfigured for the chlorinator cell that will be used.

Slide the main switch to the auto position. When illuminated steady the salt level is too low and aqua rite has shut down. The following aquarite video will help you to configure and adjust the settings on your aquarite. If the incorrect cell is chosen the salt level amperage and voltage will not be correct and the system will turn the chlorinator off.

T 15 is the factory default. Added salt to bring to 3000 and no change in readings.